Toupcam GCMOS01200KMA - no guide display

[Forum_2017]

Darn.
It seemed to work extremely well but upon closing the Camera Control window I got this error:

Access violation at address 00677157 in module AstroartLAA.exe. Read of address 00000406.

I got the same (or a very similar) error using the Astroart.exe module.

[Forum_2017]

It looks like a NULL pointer is used in the driver after termination. However that should happen only when the whole Astroart is closed, not only the Camera Control (if you are using 6.2).

[Forum_2017]

I'll check that tonight and report back.